Pipe Materials
In old construction, lead plumbing was common. It was generally eclipsed toward the end of the 1800s by galvanized iron water pipes which were attached with threaded pipe fittings. Higher durability, and cost, systems were made with brass pipe and fittings. Copper with soldered fittings became popular around 1950, though it had been used as early as 1900. Plastic supply pipes have become increasingly common since about 1970, with a variety of materials and fittings employed, however plastic water pipes do not keep water as clean as copper and brass piping does. Copper pipe plumbing is bacteriostatic. This means that bacteria can't grow in the copper pipes. Plumbing codes define which materials may be used, and all materials must be proven by ASTM, UL, and/or NFPA testing.
Steel
Tap water remains susceptible to biological or chemical contamination. In the event of contamination deemed dangerous to public health, government officials typically issue an advisory regarding water consumption. In the case of biological contamination, residents are usually advised to boil their water before consumption or to use bottled water as an alternative. In the case of chemical contamination, residents may be advised to refrain from consuming tap water entirely until the matter is resolved.
Galvanized steel supply pipes are commonly found with interior diameters from 1/2" to 2", though most single family homes' systems won't require any supply pipes larger than 3/4". Pipes have National Pipe Thread (NPT) standard male threads, which connect with female threads on elbows, tees, couplers, valves, and other fittings. Galvanized steel (often known simply as "galv" or "iron" in the plumbing trade) is relatively expensive, difficult to work with due to weight and requirement of a pipe threader, and suffers from a tendency to obstruction due to mineral deposits forming on the inside of the pipe. It remains common for repair of existing "galv" systems and to satisfy building code non-combustibility requirements typically found in hotels, apartment buildings and other commercial applications. It is also extremely durable. Black lacquered steel pipe is the most widely used pipe material for fire sprinklers.
Copper
Tubing made of copper was introduced in about 1900, but didn't become popular until approximately 1950, depending on local building code adoption.
Lead Leaching
Generally, copper tubes are soldered directly into copper or brass fittings, although compression, crimp, or flare fittings are also used. Formerly, concerns with copper supply tubes included the lead used in the solder at joints (50% tin and 50% lead). Some studies have shown significant "leaching" of the lead into the potable water stream, particularly after long periods of low usage, followed by peak demand periods. In hard water applications, shortly after installation, the interior of the pipes will be coated with the deposited minerals that had been dissolved in the water, and therefore the vast majority of exposed lead is prevented from entering the potable water. Building codes now require lead-free solder. Building Codes throughout the U.S. require the use of virtually "lead-free".
Corrosion
Copper water tubes are susceptible to cold water pitting, bad plumbing ground pinholes, and erosion corrosion.